please dont rip this site

Language Pcl LJ2076.ASC


     The Label Origin command ( LO ) positions labels
     relative to the current pen location.  For more
     information see the Updated PCL 5 Printer Language
     Technical Reference Manual.
     LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT.
     EcE                           Resets the printer.
     Ec%0B                         Enters HP-GL/2 mode.
     IN;                           Initializes HP-GL/2 mode.
     SP1;                          Selects pen number 1,
                                   (black). Even though
                                   there is no physical pen,
                                   the SP command must be
                                   used to enable printing.
     SC-4000,4000,-5000,5000;      Specifies scaling by
                                   assigning (-4000,-5000)
                                   to P1, and (4000,5000) to
     SI.17,.26;PA0,500;            Sets the absolute
                                   character size to .17 cm
                                   wide by .26 cm high;
                                   moves to (0,500).
     PD-500,0,0,-500,500,0,0,500;  Sets the pen down and
                                   draws lines from (0,500)
                                   to (-500,0), to (0,-500),
                                   to (500,0), and to
     DT#;                          Defines the label
                                   terminator as the "#"
     CI10;LO4;LBCentered on point#;     Draws a small circle
                                   (radius of 10 plotter
                                   units, plu) to represent
                                   the label origin point;
                                   specifies a label origin
                                   of 4, and prints
                                   "Centered on point".
     PU-500,0;CI10;LO18;           Lifts the pen and moves
                                   to (-500,0); draws
                                   another small circle;
                                   specifies a label origin
                                   of 18.
     LBLeft center offset#;        Prints "Left center
     PU0,-500;CI10;LO13;           Lifts the pen, and draws
                                   another small circle;
                                   specifies label origin
                                   number 13.
     LBRight offset from point#;   Prints "Right offset from
     PA500,0;CI10;LO3;             Moves to (500,0); draws
                                   another small circle;
                                   specifies label origin
                                   number 3.
     LBRight hang from point#;     Prints the last label,
                                   "Right hang from point".
     Ec%0A                         Enters PCL mode.
     EcE                           Sends a reset to end the
                                   job and eject the page.

            Copyright  Hewlett-Packard Co. 1993
   The information contained herein is subject to change
                      without notice.
   Hewlett-Packard shall not be liable for incidental or
  consequential damages in connection with the use of this

file: /Techref/language/pcl/lj2076.asc, 3KB, , updated: 1993/11/15 17:25, local time: 2024/7/15 03:36,

 ©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?
Please DO link to this page! Digg it! / MAKE!

<A HREF=""> language pcl lj2076</A>

Did you find what you needed?


Welcome to!


Welcome to!