USING THE CHARACTER SLANT ( SL ) COMMAND The Character Slant command ( SL ) specifies the slant at which labels are drawn. For more information see the Updated PCL 5 Printer Language Technical Reference Manual. The syntax for the command is as follows: SL tangent of angle; or SL; LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT. EcE Resets the printer. Ec%0B Enters HP-GL/2 mode. IN; Initializes HP-GL/2 mode. SP1; Selects pen number 1, (black). Even though there is no physical pen, the SP command must be used to enable printing. SD1,21,2,1,4,25,5,0,6,0,7,4101; Designates a 25 point CG times font as the standard (primary) font. SI.7,1;PA1000,1000; Sets the absolute character size to .7 cm wide by 1 cm high; moves to (1000,1000). DT#,1; Defines the label terminator as the "#" character, and the 1 designates it as non- printing. SL.36;LBSlant#; Sets the slant angle for 20 degrees from the vertical (forward slant), and prints "Slant." PA1000,300;SL-.36;LBSlant#; Moves to (1000,300); changes the slant angle to -20 degrees from upright and prints "Slant". Ec%0A Enters PCL mode. EcE Sends a reset to end the job and eject the page. Copyright Hewlett-Packard Co. 1993 The information contained herein is subject to change without notice. Hewlett-Packard shall not be liable for incidental or consequential damages in connection with the use of this material.
|file: /Techref/language/pcl/lj2078.asc, 2KB, , updated: 1993/11/15 16:26, local time: 2023/11/28 15:04,
|©2023 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?|
<A HREF="http://www.massmind.org/Techref/language/pcl/lj2078.asc"> language pcl lj2078</A>
|Did you find what you needed?|
Welcome to massmind.org!
Welcome to www.massmind.org!