|Description:||Call to address, clear bit 8|
|Operation:||STACK[SP++] = PC; PC = ( page << 9 ) + addr|
|Details:||SX Users Manual page # 76|
|Microchip PIC syntax:|
The call instruction clears the 9th bit (bit 8) of the PC while loading the first 8 bits (0...7) so you can only call into the first 256 instruction half page of each 512 instruction page. To allow calls to more than one page, the PA0...2 bits from the Status register are copied to the top 3 bits of the PC. See: SX Users Manual page # 34 for a good diagram of this process.
Since the call can only be to an address in the first half of each page of memory, how about defining a macro that compiles a (dual) register load of the address of the routine and then always calls a single subroutine which is placed at a low memory address which then jumps to the address specified in the registers? The return from the subroutine jumped to will be to the original call. This is very slow compaired to the direct subroutine call, but will allow the use of the upper half page of memory in a program with a lot of subroutines.
|file: /Techref/scenix/inst/call.htm, 2KB, , updated: 2003/2/15 23:52, local time: 2023/9/26 09:51,
|©2023 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?|
<A HREF="http://www.massmind.org/Techref/scenix/inst/call.htm"> SX Embedded Controller Instruction - CALL addr</A>
|Did you find what you needed?|
Welcome to massmind.org!
Welcome to www.massmind.org!