In order to setup many (most?) Cisco devices, such as the Cisco ASA 5505 / 5500 Series you must have a special console cable.
Cable: First connect to the console port via a special Cisco specific console cable. The console port on a Cisco device is the same RJ-45 connector used for CAT 5 network cables, but the signals are actually RS232 so you need a console cable to adapt the RJ-45 to a DB9 or 25 for connection to a PC serial port or a Serial to USB adapter. You can buy one or make one yourself. ^ ^ The pinout is:
|1 Green-White||8 CTS|
|2 Green||6 DSR|
|3 Orange-White||2 RX|
|4 Blue||5 GND|
|5 Blue-White||5 GND|
|6 Orange||3 TX|
|7 Brown-White||4 DTR|
|8 Brown||7 RTS|
Note: The colors listed assume TIA/EIA 568A standards, and other versions may be found. It's the numbers that matter, not the colors.
Note: That if your PC doesn't have an RS232 port, you will ALSO need a USB to Serial Adapter
Connection: Use a serial terminal program like Hyper Terminal, PuTTY, Real Term, etc... Set the baud rate to 9600 N 8 1. Or No parity, 8 data bits, 1 stop bit. Press Enter a few times and you should get a response from the device.
|file: /Techref/inet/cisco-console.htm, 2KB, , updated: 2016/2/11 15:33, local time: 2020/10/24 10:14,
|©2020 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?|
<A HREF="http://www.massmind.org/techref/inet/cisco-console.htm"> Cisco ( internet ) Console Cable Serial Connection</A>
|Did you find what you needed?|
Welcome to massmind.org!
Welcome to www.massmind.org!