A open source microcontroller platform, featuring very easy to use hardware and software based on the Atmel AVR processor, USB interface to a host PC, and a simple, C based Integrated Development Environment. The IDE has been adapted for use with MANY processors and devices, includeing the ESP-8266
Intefacing to the LCD Panel 1 by Bud Justen
The BOB Panel adds LCD, LEDs, Switchs, relay driver, or breakout to full sized stepper motor drivers.
Arduino SPI Code for ENC2 / AS5047P Magnetic Rotary Position encoder
When using the Tinyduino or other Pro / Mini versions, make sure the correct processor speed is set. The processor selection option only appears under the tool menu after the board is selected. If you have the Tinyduino set to the 5 volt / 16MHz Atmega 328, it will return garbage on the serial port. Use the Atmega 328 (3.3v, 8MHz) option for correct operation.
|file: /Techref/arduinos.htm, 6KB, , updated: 2021/11/20 13:47, local time: 2023/9/21 08:09,
|©2023 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?|
<A HREF="http://www.massmind.org/techref/arduinos.htm"> Arduino</A>
|Did you find what you needed?|
Welcome to massmind.org!
Welcome to www.massmind.org!